Filter
Top Products
Chapter 3. Removing and Reinstalling the Quad T1/E1 DTA
This chapter contains information on removing and reinstalling the Quad T1/E1 DTA
from the base adapter. In this section, the IBM ARTIC960RxD PCI Adapter is
referred to as the base adapter, and the Quad T1/E1 DTA is referred to as the
mezzanine card.
Removing the Quad T1/E1 DTA
The following procedure describes how to remove the mezzanine card from the base
adapter. The procedure varies depending on your system unit. Refer to the
documentation that came with your system unit for detailed instructions on
performing the following procedures:
Shutting down your system unit
Removing the system unit covers
Removing an adapter from the system unit
Note:
Be sure to hold the IBM ARTIC960RxD Quad DTA by the edges only; do not
touch the component pins or solder joints.
If more than one adapter is installed, remove the H.100 cable and note the state
of JP01.
1. Remove the four mounting screws from the base adapter as shown in the
following figure. (The two cards are still held together by the PMC connector.)
2. Carefully separate the connector on the mezzanine card from the connector on
the base adapter using a gentle rocking motion.
Chapter 3. Removing/Reinstalling the Quad T1/E1 DTA 3-1