Filter
Top Products
c. Move the cursor to the "SOFTWARE package to copy" option and
press F4 to select the software to be installed. Use the F7 key to
select the following device driver(s):
No Prerequisite Driver
devices.artic96
at the system prompt, then press Enter.
d. Move the cursor down to "DIRECTORY for storing software package"
and enter the appropriate lppsource destination directory:
/spdata/sys1/install/<lppsource_name>/lppsource
using the <lppsource_name> you recorded earlier.
e. Press Enter to begin copying the files.
Note: This step may take several minutes as the directory table of
contents is updated.
5. Update the SPOT (Shared Product Object Tree) by:
a. Type
smitty nim_res_op
at the system prompt. The Resource Name panel displays with
boot resources boot
highlighted.
b. Move the cursor down until the
SPOT resource
is highlighted. The
SPOT resource
should look like:
spot_AIX432 resources spot
The format of the spot name is: spot_<lppsource_name>.
<lppsource_name> was recorded in a previous step.
c. When the
SPOT resource
is highlighted, press Enter to select this
option. The Network Install Operation to Perform panel displays
with the reset option highlighted for selection.
d. Move the cursor until the cust option is highlighted and press Enter
to select this option. The Customize a SPOT panel displays with
the Source of Install Images highlighted for selection.
e. Press F4 to display the list of Install Images and select the
appropriate lppsource.
f. Move the cursor until the appropriate lppsource is displayed. For
example:
lppsource_AIX432 resources lpp_source
Chapter 4. Installing the Device Driver on the SP System 4-5