Filter
Top Products
8 Attach the fan cable by pressing firmly down until it clicks into place.
9 Position the power supply cable connector so that the side of the connector
with the tabs faces the retaining clips. Then, press firmly down until it clicks
into place.
10 Reinstall the cover. See “Reinstalling the Cover” on page 4-4 for
instructions.
Note: The customer must reload operational code and configuration infor-
mation after the system board is replaced.
Removing the System Board for 14T and 24x Models
Fan Cable
LED Panel Cable
Power Supply Cable
Reset Cable
AC Power Ground
AC Power Cable
Figure 4-12. Cables Attached to the System Board - 14T Model
Chapter 4. Removal and Replacement Procedures 4-9