Filter
Top Products
Also make sure that the connectors feed through the space between the side
and rear of the cover and the connectors without the jumpers are connected
to the power supplies.
5 Replace the screws that attach the power supply cover to the chassis as
shown in Figure 4-30 on page 4-26.
6 If the Adapter Enablement Feature is installed, position the connector to the
adapter riser card so that the side of the connector with the tabs faces the
retaining clips. Then, press firmly down until it clicks into place. Be sure it is
firmly seated.
7 Position the connector to the system board so that the side of the connector
with the tabs faces the retaining clips. Then, press firmly down until it clicks
into place. Be sure it is firmly seated.
8 If the Adapter Enablement Feature is installed, connect the jumpers between
the base power supply and the adapter power supply together.
Fan
Note: For the 14T and 24x models, removing the power supply cover will ease the
fan removal process. Instructions on removing and replacing the power supply
cover are contained in “Removing the Base Power Supply for 14T and 24x Models”
on page 4-22 and “Replacing the Power Supply for 14T and 24x Models” on
page 4-25.
Removing the Fan
Figure 4-31. Removing the Fan
Chapter 4. Removal and Replacement Procedures 4-27