Filter
Top Products
DeviceNet to Motor Drives
33
OUTPUT DATA TABLE
Within the “I/O Data Configuration” screen, use the DOWN arrow key to move the focus to the Output
Data button and press the ENTER key. This action opens the Output Data Table setup screen to allow
you to set up the motor drive parameters to be mapped to each word of Output data.
Output data is data received by the DN-3000 from the DeviceNet Host to be written to motor drive
parameters. Each word of Output data (except those reserved for the Command Block) can be mapped to
specific motor drive parameters. Output data is only written to motor drive parameters when that data
changes.
Use the UP/DOWN arrow keys to scroll through the list of Output data words until the highlight bar is
over the Output word you wish to edit, and press ENTER. A window will open allowing you to edit the
Motor Drive Address and Parameter Number mapped to that Output word.