Filter
Top Products
Software Information
3
SOFTWARE START-UP
To start the DN-3000 Configuration Editor program. First start your computer and at the MS-DOS
prompt; C:> type in “CD\DN3000” (to change the directory) then press the ENTER key. At the next
MS-DOS prompt; C:\DN3000>,
type in “DN3000” and press the ENTER key to start the
Configuration Editor Software Program.
Upon starting of the configuration software program, the first screen to appear will be the “Support
Information Page”, shown below.
After pressing the computer’s ENTER key, the support information page will disappear. Use the
computer’s LEFT/RIGHT arrow keys and move the highlighted bar (very top of the screen) between the
four (4) main system selection headers. To select any one of these main selection headers, place the
highlight bar around that desired heading and then press the computer’s ENTER key. Below is a brief
description of the main project header and each internal subheading; NOTE: These brief descriptions
listed are as the system starts without any projects opened or new projects created.
Selecting PROJECT opens a menu with the following options:
OPEN allows you to open any saved project file.
NEW allows you to create a new project file.
DOS SHELL allows you to exit to MS-DOS without closing the DN-3000 Configuration Editor
Program and return to the Configuration Editor Program by typing in EXIT and then pressing the
ENTER key.
QUIT allows you to exit the Configuration Editor Program.