Filter
Top Products
C H A P T E R 3Cable the module
12
Stand-alone Mode
Cabling for a single switch
Follow these instructions to provide a high-speed (1000Base-SX) link
between the switch containing the 1000SX Advanced Module and an-
other switch, device or group of switches:
Warning When used in stand-alone mode, this module must not be
installed in a switch containing a Stack Interface Module,
a Matrix Module or a 1000Base Module set in stack
mode.
1 Plug the SC connectors on the optic fiber cable into the RX and
TX sockets on the 1000Base-SX connector.
2 Plug the other end of the cable into a device and check the LEDs
on the 1000SX Advanced Module to verify the link. For informa-
tion on the LEDs, see Chapter 2.
1000Base-SX
Stack Interface Module
CLASS 1 LASER PRODUCT
1000SX Advanced Module for 500 Series Switches
5004
A23295.book Page 12 Wednesday, August 30, 2000 1:16 PM