Filter
Top Products
C H A P T E R 4Configure the module
20
Configuring the module
To change the module mode using Intel Device View
The default settings for the Module Mode is Stack Mode and 802.1Q
VLAN tagging disabled. With the switch containing the 1000SX Ad-
vanced Module displayed in the Device View window:
Warning Changing mode causes Intel Device View to save the
switch configuration and reset the switch.
1 Right-click the 1000Base-SX port on the module and select Port
Setup.
2 Click the Module tab.
3 Select the correct modes.
Note When 802.1 Q tagging is disabled, tagged frames
received on all ports are forwarded without recogniz-
ing the tag. When 802.1 Q is enabled, only tagged
frames received on the module’s 1000Base port are
recognized. Tagged frames received on the front ports
of the switch are discarded.
4 Click OK. The configuration is saved and the switch reset.
A23295.book Page 20 Wednesday, August 30, 2000 1:16 PM