Filter
Top Products
C H A P T E R 2 Intel Express 100BASE-TX Stackable Hub
16
2. Install any optional modules in the media adapter and/or
expansion slots in the hub.
a. Remove the filler panel from the slot.
For instructions on removing filler panels, see “Installing and
Removing Filler Panels” later in this chapter.
b. Install the module in the appropriate slot.
The media adapter fits into the media adapter slot. For
instructions on installing a media adapter, refer to the
documentation that shipped with your media adapter.
The NMM fits into the expansion slot. For instructions on
installing an NMM, refer to the documentation that shipped
with your NMM.
The 100BASE-TX Host Module fits into the expansion slot.
For instructions on installing a 100BASE-TX Host Module,
refer to the documentation that shipped with your host module.
3. Make the connections to the ports on the hub and optional
installed media adapter and host module.
For instructions on making connections to ports, see “Making
Connections to 100BASE-T Ports” in Chapter 3.
4. When installation for each unit in your stack is complete, connect
the power cord(s) to the hub.
Connect the power cord(s), first to the power entry receptacle on
the hub rear panel and then to the wall.
5. Verify the installation.
For instructions on verifying the installation, see “Verifying
Installation” in Chapter 3.
CAUTION
The power cord is a North
American type, UL-listed/
CSA-certified power supply
cord. Immediately discard
this cord if it is inappropriate
for the electrical system of
your country, and obtain the
proper cord as required by
your national electrical codes
or ordinances.