Filter
Top Products
20
Jumper Options and Locations
The cPB-4612 contains a push-button switch on the faceplate and eight jumpers on the component side
of the board. The jumpers are listed and briefly described in the "Jumper Cross-Reference" table below.
Factory default switch settings are shown in the "Default Jumper Settings" figure.
Jumper Cross-Reference Table
Jumper Function
PB1 Reset (push-button on faceplate)
J16-1 BKT-GND to GND
J16-2 +12V to J5-pin D1
J16-3 +5V PMC I/O
J16-4 IMPI Disable
J17-1 Not Used
J17-2 CMOS Clear
J17-3 Disable Onboard Video
J17-4 Manufacture Test Mode