Filter
Top Products
52
Onboard Peripheral Control Descriptions
Video Controller: This item displays the enable/disable status of the onboard video
controller.
Graphics Memory Select: Selects the amount of system memory used by the internal graphics
device. The choices are 1MB, 4MB, 8MB, 16MB, or 32MB.
Ethernet Controller: This item controls the enable/disable of the 10/100 Ethernet controller.
The default is enabled.
Ethernet Boot ROM: Controls the embedded Ethernet boot ROM allowing for remote network
booting.
Dual Gigabit Ethernet Controller: This item controls the enable/disable of the dual 10/100/1000 Ethernet
controller. The default is enabled.
Gigabit Ethernet Boot ROM: Controls the embedded gigabit Ethernet boot ROM allowing for remote
network booting.
Console Redirection Descriptions (Disabled by default)
Remote Access: This item allows serial console redirection to be enabled. This allows all
video output to be redirected through the serial port during the POST and
DOS. In addition, input through the serial port will be used through the
POST and DOS.
Serial Port: Specifies the serial port to be used for console redirection.
Serial Port Mode: Selects the baud rate for console redirection. The possible baud rates
are: 9600, 19200, 38400, and 115200.
Flow Control: This item allows hardware flow control to be used.
Terminal Type: Selects between ANSI and VT100 terminal types.
VT-UTF8 Combo Key Support: Controls VT-UTF8 combination key support for ANSI and VT100
terminals.
Redirection After BIOS Post: Control if console redirection is to be used after POST.
I/O Port Control Descriptions
Serial Port Address: The three serial ports can be configured to one of four possible settings
or disabled.
Serial Port IRQ: The three serial ports can be configured to one of four possible settings.