Filter
Top Products
User’s Manual
102 ECB-865 User’s Manual
Code Description
9A Return after setting timer and printer base address. Going to set the
RS-232 base address.
9B Returned after setting the RS-232 base address. Performing any
required Initialization before the Coprocessor test next.
9C Required initialization before the Coprocessor test is over. Initializing
the Coprocessor next.
9D Coprocessor initialized. Going to do any initialization after Coprocessor
test.
9E Initialization after the Coprocessor test is complete. Checking the
extended Keyboard, keyboard ID, and Num Lock key next. Issuing the
keyboard ID command next.
A2 Displaying any soft errors next.
A3 Soft error display complete. Going to set keyboard typematic rate.
A4 Keyboard typematic rate set. To program memory wait states.
A5 Memory wait state programming is over. Clearing the screen and
enabling parity and the NMI next.
A7 NMI and parity enabled. Performing any initialization required before
passing control to the adaptor ROM at E000 next.
A8 Initialization before passing control to the adaptor ROM at E000h
completed. Passing control to the adaptor ROM at E000h next.
A9 Returned from adaptor ROM at E000h control. Performing any
initialisation required after the E000 option ROM had control next.
AA Initialization after E000 option ROM control has completed. Displaying
the system configuration next.
AB Building the multiprocessor table, if necessary.
AC Uncompressing the DMI data and initializing DMI POST next.
B0 The system configuration is displayed.
B1 Copying any code to specific areas.
00 Code copying to specific areas is done. Passing control to INT 19 h
boot loader next.