Filter
Top Products
ECB-865
ECB-865 User’s Manual 13
3.5 M-Systems’ DiskOnChip Flash Disk
ECB-865 reserves a 32-pin DIP socket to support M-Systems’ DiskOnChip flash disk up to
288 MB. The DiskOnChip is based on pure ISA bus and without PnP (Plug and Play)
function. Before the installation, make sure that the DiskOnChip I/O address jumper is set
properly to prevent the I/O resource conflict.
3.5.1 Installing DOC
Align the DOC with the pinholes on the socket. Make sure that the notched corner or dot
mark (pin 1) of DOC corresponds to notched corner of the socket. Then press the DOC
gently until it fits into place. If installation procedure is correct, the flash disk can be viewed
as a normal hard disk to access read/write data now.
Note:
Please make sure that your DOC is properly inserted. Place the DOC in wrong
direction will damage the flash device.
If you system would like to boot from the flash disk, it is recommended to refer to the
application note provided by M-Systems first. You can easily obtain the application note
from M-Systems’ DiskOnChip user’s manual or from their web site as below.
http://www.m-sys.com
3.6 Expansion Interface
The ECB-865 reserves an 80-pin proprietary PCI interface, J22, for PCI device such as
LAN, Audio, SCSI, Video Capture expansion in the future. This installation of expansion
module is very simple and easy. Without any special tool, all you need to do is just make
the board-to-board connection and lock up the screw. For more information about the
expansion module, please refer to the instruction manual attached with each module.
3.7 Installing the Single Board Computer
To install your ECB-865 into chassis or proprietary environment, the following steps have
to be followed.
Make sure all jumpers are properly set.
Install and configure CPU and memory module correctly.
Place the ECB-865 into the dedicated position in your system.
Attach cables to peripherals.
Note:
Please ensure that your SBC is properly installed and fixed by mechanism.
Otherwise, the system might be unstable or do not work due to bad contact of
golden finger and slot.