Filter
Top Products
PX875P PRO/ PX875P
10
H
This section will assist you in quickly installing your system hardware. Wear a wrist ground strap
before handling components. Electrostatic discharge may damage your system components.
CPU Processor Installation
This mainboard supports Intel
®
Pentium
®
4 processors using a Socket 478. Before building your
system, we suggest you visit the Intel website and review the processor installation procedures.
http://www.intel.com
ardware Installation
CPU Socket 478 Configuration Steps:
1. Locate the CPU socket on your mainboard and nudge the lever away from the socket. Then lift
the lever to a 90-degree angle.
2. On the socket, locate the corner that has the pin-1 receptor. This corner will be near to the end of
the lever. Match the dot on the CPU with the pin-1 receptor on the socket and lower the CPU onto the
socket. The bottom of the CPU should be flush with the face of the socket.
3. Lower the lever until it snaps back into position. This will lock down the CPU.
4. Smear thermal grease on top to the CPU and use the clasps on
the fan to attach it to the sock from the fan and insert it onto the
CPUFAN adapter.
of the CPU. Lower the CPU fan on
et. Finally, extend the power cable
Pin1 Receptor
Dot
Attention
Overheating may damage the C
Please check the installation c
PU and other sensitive components.
ompletely before starting the system.
Make sure the heatsink and the CPU fan are properly installed.