Filter
Top Products
PX875P PRO/ PX875P
38
RxD, TxD Active
This item determines the RxD and TxD frequencies. This field only configurable if “UART Mode
Select” is set to “ASKIR” or “IrDA”. Options: Hi / Lo (default)、Hi / Hi、Lo / Hi、Lo / Lo
figurable if “UART
led
ode used by the IR interface. Full-duplex mode permits simultaneous
ode permits transmission in only one direction at a time.
Select” is set to “ASKIR” or “IrDA”.
al documentation to select the correct setting of the TxD and RxD signals.
nboard Parallel Port
ding interrupt for the onboard parallel port.
his option allows you to select a parallel port mode for the onboard parallel port.
Capabilities Port.
SPP Standard Printer Port.
ECP & EPP mode.
is se P”
IR Transmission Delay
This item allows you to enable/disable IR transmission delay. This field only con
Mode Select” is set to “ASKIR” or “IrDA”. Options: Enabled (default)、Disab
UR2 Duplex Mode
Select the transmission m
bi-directional transmission. Half-duplex m
his field only configurable if “UART ModeT
Options: Half (default)、Full
Use IR Pins
Consult your IR peripher
This field is only configurable if “UART Mode Select” is set to “ASKIR” or “IrDA”.
Options: Full、Half (default)
O
Select an address and correspon
Options: 378/IRQ7 (default)、278/IRQ5、3BC/IRQ7、Disabled
Parallel Port Mode
T
Options: ECP(default) Extended
EPP Enhanced Parallel Port.
ECP+EPP
Normal
EPP Mode Select
Select EPP port type 1.7 or 1.9. This field is only configurable if “Parallel Port Mode” t to “EP
or “ECP+EPP”. Options: EPP 1.9(default)、EPP 1.7