Juniper Networks ERX-700 Network Router User Manual


 
APPENDIX E
Installing ERX System Software
E-8
To install the software, perform the following tasks:
1 Obtain the required information for the installation.
2 Access the Privileged Exec CLI command mode.
3 Configure IP on an interface.
4 Configure access to the network host.
5 Mount the CD on the network host.
6 Copy the software release file to the ERX system.
7 Save the current configuration.
8 Reboot the system.
Task 1: Obtain the Required Information
Before you install the software, obtain the following information:
The password (if one is configured) that allows you to access Privileged
Exec mode on the ERX system
The IP address of the network host
The IP address of the ERX system
The IP address of the next hop to reach the destination network (for
example, a gateway)
The login name and password for the FTP server
The procedure for mounting a CD on the network host
Task 2: Access Privileged Exec Mode
To access this mode via the CLI:
1 Issue the enable command.
host1>enable
2 Type the password if the system prompts you.
Task 3: Configure IP on an Interface
Typically, you configure IP on the Fast Ethernet interface of the SRP
module. To configure IP on an interface:
1 Determine the slot number of the module.
host1#show version