Juniper Networks ERX-700 Network Router User Manual


 
CHAPTER 2
Installing the ERX System
2-4
Figure 2-3 Removing an L-bracket
8 Depending on where you want to position the system, proceed to
Freestanding Installation or Rack-Mounted Installation, later in this
chapter.
Unpacking the ERX-700 Series
The ERX-700 series come boxed but not attached to a skid.
For your convenience, we recommend that you unpack the ERX system
in the location where you want to install it.
To unpack the ERX-700 series:
1 Open the carton from the top.
2 Remove the box of accessories that sits on top of the system.
3 Before you remove the unit from its carton, proceed to Freestanding
Installation or Rack-Mounted Installation, later in this chapter.
Shipping
skid
Hex bolts
L-brackets