Filter
Top Products
Networking Your Printer
12 www.kodak.com/go/aiosupport
Connecting to a WPS wireless router
If your router supports Wi-Fi Protected Setup (WPS), you can use WPS Connect.
WPS lets you configure your printer for a wireless network by pressing buttons or
entering a PIN.
1. Press .
2. Touch , then touch Network Settings.
3. Touch Wi-Fi Setup Wizard.
NOTE: The Wi-Fi radio turns on automatically when you select Wi-Fi Setup
Wizard.
4. Touch WPS Connect.
5. Select one of two methods of connecting:
IMPORTANT: Before you make a selection on the printer, make sure you know where
the router's push button is, or where to enter the generated PIN. If
necessary, consult your Internet service provider or router device
manufacturer’s documentation for more information.
6. When the confirmation message appears, touch OK.
Push Button Configuration Generate WPS PIN
NOTE: You will have two minutes to
press or select the WPS button.
It may be a button on the device
or a virtual button in the device’s
software.
a. Touch Push Button Configuration.
b. Press or select the WPS button for
your wireless router.
c. Touch OK on the control panel.
a. Touch Generate WPS PIN.
b. Record the PIN from the printer
LCD.
c. In your wireless router’s
software, locate the PIN screen.
d. Enter the PIN you received on the
LCD into the PIN screen, then
follow the router’s instructions.
e. Touch OK on the control panel.