Filter
Top Products
Getting Started
1–31
January 1998
Specifying Port Information
Use the SETUP:PORTS menu to change the default port information.
Press the Setup/Select button to get into the SETUP:PORTS submenu.
The options you select must match your host computer settings.
NOTE: The submenus that appear for this menu depend on whether the
Network Interface Card is installed in the printer.
Setting up a Parallel Connection
Use the PORTS:PARALLEL menu to establish information about
connecting the printer through a parallel port. The new option will be in
place once you exit Setup mode.
PARA:MODE—This menu specifies whether the parallel port should
accept data in normal PostScript mode or in Adobe binary mode. Normal
PostScript mode can only support printable characters; it does not accept
characters in the high ASCII range (128–255). Adobe binary mode
supports the high ASCII range. Full 8-bit data may be sent.
The following settings are available.
MODE:NORMAL*
MODE:BINARY
MODE:EXIT
Select MODE:EXIT once you have made your selection, and PARA:EXIT
when you are done.