A-61003 September 1993EB-8
Setup:
√ Turn on main power switch, if necessary.
√ Turn on side panel switch.
√ Load film into cassette(s).
√ Load film cassette(s) into machine.
√ Select the lens holder position.
√ Select the mask.
√ Calibrate the machine.
√ Adjust the feed/separator rollers.
√ Adjust the feed shelf.
√ Adjust the feed shelf length.
√ Adjust the feeder side guides.
√ Adjust the exit hopper side guides.
√ Adjust the exit hopper end stop.
√ Install the proper exit hopper deflector.
√ Perform an exposure step test, if necessary.
√ Prepare documents to feed into transport.
Running a Job:
√ Enable the machine from the host system.
√ Select an application mode.
√ Input any temporary/override operating values.
√ Enter or verify the starting Image Address.
√ Enter or verify the starting document image level.
√ Press the Run key.
√ Feed documents.
√ Press the Stop key.
√ Execute Scanner End-of-Job.
√ Remove documents from the exit hopper.
√ Unload film cassette(s) from the machine.
√ Unload film from the cassette(s), if necessary.
√ Turn off side panel switch.
√ Turn off main power switch, if necessary.
Scanner/Microimager 990:
