Filter
Top Products
A-61003 September 1993OM-10
Code Operator Message Displayed Description/Action Required
E281 OCR was reset - restart batch Use the NEXT key to enter a starting
Image Address.
Rerun the batch.
E282 Comm buffer full - please wait System is busy.
Wait until the message clears and
continue.
E283 Invalid configuration for OCR OCR is not enabled in the mode selected.
Enable the OCR using function code
F76, or
change the application mode to one
in which the OCR is enabled.
E284 OCR initializing - please wait System is busy.
Wait until the message clears and
continue.
E285 Feeder off due to OCR request System is busy.
Feeder will be reactivated when the
system is no longer busy.
Wait until the message clears and
continue.
E286 Feed calibration target Calibration process has started.
Press the Run key and feed the
calibration target into the transport.
E287 Feeder waiting for AEC Turn the side panel switch off.
Turn the main power switch off.
Wait five (5) to ten (10) seconds.
Turn the main power switch on.
Turn the side panel switch on.
If the error repeats, call service.
E288 OCR batch stopped due to error Determine the cause of the error
via the OCR Workstation interface.
Correct the error. Rerun the batch.
E291 Scanner disabled The machine has been disabled due to
an error.
Determine the cause of the error
via the host system.
Enable the machine.
Press the Run key to continue.