Filter
Top Products
A-61003 September 1993
OM-1
If a message appears in the Status Display which is within the
ranges E000-E299 or E500-E599, you should take the action
indicated in the table(s) which appear in this section.
IMPORTANT: Never power down the machine without first
contacting your System Administrator.
If a message appears in the Status Display which is within the
ranges E300-E499 or E600-E999, you should contact your
System Administrator.
If a message appears in the Status Display which is within the
ranges E300-E499 or E600-E999, you should be contacted by
the operator.
The following action(s) should be taken:
• Determine whether or not the error can be addressed from the host
system, if applicable.
• Attempt to clear the error by taking the action indicated in the
table(s) which appear in this section.
• If the prescribed action(s) do not clear the error, initiate a controlled
power-down sequence:
- Wait for all information currently held in the buffer to be transferred
to the host system, if applicable.
- Turn off the Scanner/Microimager transport using the side panel
switch.
- Turn off the Scanner/Microimager power using the main power
switch.
- Wait 10 - 30 seconds.
- Turn on the Scanner/Microimager power using the main power
switch.
- Turn on the Scanner/Microimager transport using the side panel
switch.
• If the error condition is not cleared using the controlled power-down
sequence, contact service.
OPERATOR MESSAGES
Users
System Administrators