Filter
Top Products
A-61003 September 1993
OM-3
Code Operator Message Displayed Description/Action Required
E112 Invalid patch level Invalid patch was used.
Feed correct patch.
E113 Enter correct Image Address Use the NEXT key to enter correct Image
Address.
E114 Check current level Check the current document image level.
Conflicting input regarding the proper level
was received.
E115 Verify correct cassettes Verify that both cassettes are to be used
together before proceeding with filming
mode setup.
E117 Enter correct level/Image Address Document image level assignment and
E118 next Image Address input conflict.
E119 Specify another document image level, or
use the NEXT key to enter a valid Image
Address.
E120 Diagnostic running - do not use Please do not use; the machine is being
serviced.
E121 Check front patch reader Patch code not recognized.
E122 Check rear patch reader Verify that the patch document was fed
into the transport in the proper orientation.
If not, refeed the patch document.
If so, change to a non-patch mode to
continue. Call service.
E123 Command data rejected - resend Command not recognized.
Enter command again.
E124 Command not allowed in this model Command cannot be performed.
E125 Enter a valid command.
E126 Enter correct command Press correct key(s) for mode selected.
E127 Feeder waiting for host system System is busy. No action required.
Wait for message to clear.
E128 Feeder adjustment warning Check and adjust feed and separator
roller gap.