Filter
Top Products
14 A-61512 May 2006
1. Use the power switch on the back of the scanner to turn the scanner
on (I).
When you turn on the scanner, the scanner goes through a series of
self tests, the green indicators will flash. When it is finished and
ready to scan, the LED indicator will stop flashing and stay green.
NOTES:
• If the scanner does not pass the self test, refer to Chapter 6,
Troubleshooting.
• The following screens are based on Windows 2000. However,
depending on the computer operating system you are using,
these screens may be different.
Your operating software will now auto detect the scanner.
During the final installation process, this screen may be displayed:
2. If the above screen is displayed, select Yes. The installation of the
Kodak device driver for the scanner is complete. To test the
scanner, refer to the section entitled, “Verifying your scanner
installation” in Chapter 3.
If the driver installation was unsuccessful, see the section entitled,
“Scanner not working” in Chapter 6, Troubleshooting.