Filter
Top Products
A-61512 May 2006 19
Start and stop
scanning
Before you start scanning, make sure the scanner is on and ready for
operation, which is indicated by the green indicator light being on and
constant.
Scanning is controlled by software developed for your application. To
start and stop scanning, refer to the documentation provided with your
application software.
Document
preparation
• A batch of documents to be fed into the scanner must be arranged so
the leading edges of all documents are aligned and centered in the
input tray; this allows the feeder to introduce documents into the
scanner one at a time.
• Staples and paper clips on documents may damage the scanner and
documents. Remove all staples and paper clips before scanning.
• Documents should be in good condition.
Paper Types: Bond, Laser, Inkjet, Offset
NOTE: Chemically coated papers may cause excessive wear/swelling
of the rollers.
Paper inks: All inks on the paper must be dry before scanning is
started. This includes: Standard offset printing, Inkjet printer, Thermal
transfer, Handwriting inks.
Correction Fluids: Liquid Paper®, Tipp-Ex®, Wite-out®, and other
similar correction fluids.
Paper Weights: 7.3 to 12.7 kg (16 to 28 lbs.)
NOTE: Thicker paper weights can be fed through the special document
feeder. Documents up to 95 mm (3.74 in.) wide can be up to 1
mm (0.039 in.) thick.
Maximum Document Size: 21.6 x 86.36 cm (8.5 x 34 in.)
NOTE: Long Paper mode will scan document lengths from 35.56 cm
(14 in.) to 86.36 cm (34 in.) when the host PC is configured with
adequate memory (see “System requirements” for more
information regarding memory requirements).
Minimum Document Size: 8.9 x 5 cm (3.5 x 2 in.)
special document feeder only:
Front-feed minimum/center alignment: 6.35 x 5.08 cm (2.5 x 2.0 in.)