Filter
Top Products
Setting up your EasyShare digital camera
10 www.kodak.com/go/support
Refreshing the Ni-MH rechargeable battery pack
If you are getting fewer than 20 pictures per charge with your Ni-MH
rechargeable battery pack, follow the tips under Extending battery life,
page 8. If these don’t help, the battery pack needs to be refreshed. The refresh
cycle completely discharges the battery pack, then fully recharges it.
NOTE: A full refresh cycle can take up to 8 hours, depending on how much charge is left in your
battery pack. For best results, refresh the battery pack overnight; do not interrupt the
discharge/recharge cycle.
1 Make sure the Ni-MH rechargeable battery pack is in the camera.
2 Place the camera on the printer dock (see page 9).
3 Press and hold the Battery charging
lights/Refresh button,
, until the
Battery charging lights begin flashing green
(approximately 5 seconds).
The charging lights monitor the refresh status:
NOTE: Refreshing works with the Kodak EasyShare Ni-MH
rechargeable battery pack only; Li-Ion batteries do not
require refreshing.
Descending blinking
green lights
Discharging battery pack
(lights turn off as
discharging progresses).
Ascending steady
green lights
Charging battery pack
(lights turn on as charging
progresses).
Charging is complete when
all three lights are lit.