Filter
Top Products
Troubleshooting
46 www.kodak.com/go/support
Transfer button/light
Light status Cause Action/solution
Light glows steady
green
The printer dock is ready for
transferring pictures.
None required.
Light blinks green Pictures are being
transferred to the
computer.
None required.
After transferring pictures, the
transfer light continues to blink
green until either the Transfer
button is pressed again or the
connection has timed-out.
Light is off There are no pictures in the
camera, on the card, or on
the PictBridge compatible
device.
None required.
To enable Transfer:
1 Connect printer dock to
computer (page 25).
2 Take pictures.
3 Dock the camera or connect a
compatible Kodak card reader
(page 14) or PictBridge
compatible device (page 12). If
using a card reader, make sure
a memory card is inserted.
The camera is not docked, a
compatible Kodak card
reader or PictBridge
compatible device is not
connected, or a memory
card is not inserted.
The printer dock is not
connected to the computer.
The camera is not properly
seated on the connector.
Reseat the camera on the printer
dock (page 9).
The printer dock is printing
in standalone mode.
The Transfer button is disabled.
The computer is off. Turn on the computer.