Filter
Top Products
Getting started
2 www.kodak.com/go/support
Finding a location for your printer dock plus
■ Place the printer dock on a flat, clean, dust-free surface, in a dry location,
and out of direct sunlight.
■ Allow at least 5 in. (12.7 cm) clearance from
the back of the printer dock for paper travel.
■ For proper ventilation, make sure the top and
back of the printer dock are not blocked.
■ When connecting power or USB cables, keep the cables clear of the paper
path to the front and rear of the printer dock.
■ Avoid areas where ventilation ducts, open doors, or frequent passersby
might expose the printer dock and paper to high levels of dust and debris.
Airborne dirt particles can affect picture quality.
■ Allow enough space on all sides of the printer dock to let you connect and
disconnect cables, change the color cartridge, and add paper.
Installing the custom camera insert
The Kodak EasyShare printer dock plus comes with a universal camera insert
already installed. The insert allows most Kodak EasyShare CX/DX6000/7000
series and LS600 series digital cameras to fit on the printer dock.
For best fit, use the custom camera insert that came with your camera and
keep the universal camera insert as a spare.
NOTE: For some cameras, including LS700 series, you
must
use the custom camera insert to dock
the camera, otherwise the camera will not fit on the printer dock.
1 Remove the universal camera insert:
a Push the insert toward the back of the
printer dock and lift up the front edge.
b Lift up the back edge of the insert and
remove.
5 in.
(12.7 cm)