Filter
Top Products
A-61527 May 2006 23
Installing and adjusting
the output tray
The output tray receives scanned documents from the automatic
document feeder after they are scanned. Before scanning documents,
be sure the output tray is properly installed and adjusted.
To install and adjust the output tray:
1. Hold the output tray at about a 30° angle.
2. Insert the three tabs on the output tray into the three slots on the
automatic document feeder.
3. Lower the tray to lock it into place.
4. Pull the output tray extension wire out to the desire length.
Lifting the flatbed
cover
If you have a large book you want to scan (i.e., telephone book), you
can lift the flatbed cover to provide easy access to the flatbed.
Start and stop
scanning
Before you start scanning, make sure the scanner is on and ready for
operation, which is indicated by the green indicator light being on and
constant.
Scanning is controlled by software developed for your application. To
start and stop scanning, refer to the documentation provided with your
application software.