Filter
Top Products
34 A-61527 May 2006
Using the TWAIN
Datasource
The TWAIN Datasource is a piece of software that communicates with
your Kodak Scanner. It is provided with the i55 and i65 Scanners. Many
scanning applications support the TWAIN standard and this datasource
can be used to interface with these applications.
This section provides descriptions of the scanner features using options
on the TWAIN tabs and how to set these options. If you are using the
TWAIN Datasource, follow the procedures in this section to set up your
scanner. If you are using the ISIS Driver, see the section entitled,
“Using the ISIS Driver” later in this chapter.
For the purpose of this manual, all displayed dialog boxes assume the
features on the Kodak i65 Scanner (duplex scanner). If you have a
Kodak i55 Scanner (simplex scanner) options are limited to simplex
scanning only.
Kodak Scanner
Properties dialog box
The Kodak Scanner Properties dialog box allows you to review and
configure the scanner’s settings. It consists of several tabbed windows
each of which will be described within this chapter. Click on each tab to
set all the desired values. You do not have to click OK until you have
made all selections on all of the tabs.
Buttons on the Kodak
Scanner Properties dialog
box
The buttons at the bottom of the dialog box are described below:
Defaults when you select Defaults, the message Reset all values
to factory defaults? will be displayed. Clicking Yes on this message
will reset all values on all tabs to the factory default settings.
Copy copies the settings of the front camera to the rear camera for
the selected camera (bi-tonal, color or grayscale). For example, if you
have Front Bi-tonal highlighted, these values will be copied to the
Rear Bi-tonal camera. If you have Front Color highlighted, these
values will be copied to the Rear Color camera. This option is only
available for the Kodak i65 Scanner.
OK saves the values set on all tabs.
Cancel closes the dialog box without saving any changes.