Filter
Top Products
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VP-725XLA Presentation Switcher / Scaler
14
2. Connect one or more of the following balanced stereo audio sources
1
:
UXGA sources 1 to 4 to the UXGA AUDIO INPUT terminal block
connectors (from 1 to 4)
CV sources 1 to 4 to the CV AUDIO INPUT terminal block
connectors (from 1 to 4)
s-Video sources 1 to 4 to the YC AUDIO INPUT terminal block
connectors (from 1 to 4)
Component video/ RGB sources 1 to 4 to the COMP AUDIO INPUT
terminal block connectors (from 1 to 4)
3. Connect a microphone to the Mic IN XLR connector
1
, and push in or
release the Dyn / Con switch as appropriate (see item 13 in
Table 2
).
4. Connect the CV OUT BNC connector and the UXGA OUT 15-pin HD
connector to the respective video inputs on a projector.
Connect the respective AUDIO OUTPUT terminal block connectors
(CV and UXGA) to balanced audio acceptors (for example, audio
amplifiers
1
).
5. Connect the COMP OUTPUT BNC connectors: G/Y, B/Pb, and R/Pr to
the respective component video inputs on an LCD display.
6. Connect up to three SCALED OUTPUTS, as follows:
Connect the RGBHV connectors (H, V, R/Pr, G/Y, and B/Pb) to the
RGBHV acceptor (for example, a projector)
Connect the HDMI connector to the HDMI acceptor (for example, an
LCD display)
Connect the UXGA connector to the UXGA acceptor
1
7. Connect the MASTER OUT terminal block connector to the balanced
audio input on the audio amplifier, and route the audio input
(corresponding to the converted video input) to the MASTER OUT
1
.
8. Connect the power cord
1,2
.
9. Connect a PC (optional), see section
6.3.
10. Connect the Ethernet port (optional), see section 6.4
.
1 Not illustrated in Figure 3
2 We recommend that you use only the power cord that is supplied with this machine