Kyocera FS-1900 Printer User Manual


 
Interface
1-79
6
Press the > key. Each time the or key is pressed, the display
changes as shown below.
7
The following example explains how to activate TCP/IP protocol to
connect the printer in the network. You can select Netware or
EtherTalk in a similar manner.
If TCP/IP is currently Off is displayed, select On using the or
key. Press the ENTER key again.
>NetWare >
On
>TCP/IP >
On
>EtherTalk
Off
>Opt. StatusPage
On
Set this item to On when you connect to a
network using NetWare. In submenu (
>
),
frame mode can be selected from
Auto
,
Ethernet
,
802.2
, and
802.3
.
Set this item to On when you connect to a
network using TCP/IP. Submenu (
>
) has
items including DHCP, IP address, subnet
mask address, and gateway address.
When the item is set to On, the printer prints
out a network status page when it prints the
printer status. See page 1-19
Range
EtherTalk must be activated (
On
) for
networking with Macintosh computers.
>TCP/IP >
On
>TCP/IP
? On
>TCP/IP >
On