Filter
Top Products
10
10-11
Troubleshooting
Responding to an Error Lamp Flashes
If an error lamp flashes, press [Status/Job Cancel] to check an error message. If the message is not indicated on the
Message Display when [Status/Job Cancel] is pressed or the error lamp flashes for 1.5 seconds, check the following.
Symptom Checkpoints Corrective Actions Reference Page
Cannot send fax. Is the modular cord
connected correctly?
Connect the modular cord
correctly.
—
Is Permitted FAX No. or
Permitted ID No.
registered correctly?
Check Permitted FAX No.
and Permitted ID No..
FAX Operation Guide
Chapter 6 "Registering
Permit FAX No." and
"Registering Permit ID
No."
Has a communication
error occurred?
Check error codes in the
TX/RX Result Report and
Activity Report. If the error
code starts with "U" or
"E", perform the
corresponding procedure.
FAX Operation Guide
Appendix
"Error Code List"
Is the destination FAX line
busy?
Send again. —
Does the destination FAX
machine respond?
Send again. —
Is there an error other
than above?
Contact your Service
Representative.
—