Filter
Top Products
Preparation before Use
2-48
Loading Originals
Follow the steps below to load originals for copying, sending or storing.
Placing Originals on the Platen
You may place books or magazines on the platen in addition to ordinary sheet originals.
1 Open the document processor.
NOTE: Before opening the document processor, be sure
that there are no originals left on the original table or on the
original eject table. Originals left on the original table or on
the original eject table may fall off when the document
processor is opened.
Keep the document processor open if the original is 40 mm
or thicker.
2 Place the original. Put the scanning side facedown and
align it flush against the original size indicator plates with
the back left corner as the reference point.
3 Close the document processor.
IMPORTANT: Do not push the original cover forcefully when
you close it. Excessive pressure may crack the platen glass.
Do not close the document processor when the original is
40 mm or thicker.
NOTE: Shadows may be produced around the edges and in
the middle of open-faced originals.
CAUTION: Do not leave the document processor open as
there is a danger of personal injury.