Filter
Top Products
333
7. REMARKS
Do's And Don'ts
R
CAUTION:
• Do not press areas on or around the fusing unit. These areas get hot.
• After making copies continuously, the exposure glass may feel warm—this is
not a malfunction.
• You might feel warm around the ventilation hole. This is caused by exhaust
air, and is not a malfunction.
• Do not turn off the operation switch while copying or printing. Make sure
that all copying or printing has finished.
• The machine might fail to produce good copy images if condensation forms
inside the machine due to rapid temperature change. To prevent this prob-
lem, the machine has an anti-condensation function. Even after the main
power switch is in the stand-by position, the anti-condensation heater is ac-
tive, thus keeping the machine body slightly warm.
• Do not open the covers of machine while copying or printing. If you do, mis-
feeds might occur.
• Do not move the machine while copying or printing.
• If you operate the machine improperly or a failure occurs on the machine,
your machine settings might be lost. Be sure to take a note of your machine
settings.
• Supplier shall not be liable for any loss or damages resulting from a failure on
the machine, loss of machine settings, and use of the machine.
•
Unplug the power cord from the wall outlet before you move the equipment.
While moving the equipment, you should take care that the power cord will
not be damaged under the equipment.