Filter
Top Products
Configuration Via Serial Mode or Telnet Port
WiPort™ User Guide 5-17
Email Configuration
Note: Change these settings via Telnet or serial connections only, not on the
Web-Manager. These settings are also configurable through DeviceInstaller.
The unit sends an Email to multiple recipients when a specific trigger event occurs.
There are three separate triggers, based on any combination of the configurable pins
(PIO) when selected as user I/O functions. Optionally, use a two-byte serial string to
initiate a trigger. To configure Email configuration settings, select option 3 Email from
the Change Setup menu.
Figure 5-7. Email Settings
*** E-mail
Mail server: 0.0.0.0
Unit :
Domain :
Recipient 1:
Recipient 2:
- Trigger 1
Serial trigger input: disabled
Channel: 1
Match: 00
Trigger input1: X
Trigger input2: X
Trigger input3: X
Message :
Priority: L
Min. notification interval: 1 s
Re-notification interval : 0 s
- Trigger 2
Serial trigger input: disabled
Channel: 1
Match: 00
Trigger input1: X
Trigger input2: X
Trigger input3: X
Message :
Priority: L
Min. notification interval: 1 s
Re-notification interval : 0 s
- Trigger 3
Serial trigger input: disabled
Channel: 2
Match: 00
Trigger input1: X
Trigger input2: X
Trigger input3: X
Message :
Priority: L
Min. notification interval: 1 s
Re-notification interval : 0 s
Server (0.0.0.0) ? ( 0) _
Mail Server
Enter the IP address of the mail server. Enter each 3-digit section and press Enter
between each section inputted. The current value is displayed in parentheses.
Mail Server (0.0.0.0) ? ( 0) _