Filter
Top Products
Configuration Via Serial Mode or Telnet Port
WiPort™ User Guide 5-21
Disable SNMP
For security purposes, disable SNMP (if required) on the WiPort unit. The current
setting is displayed in parentheses.
Disable SNMP (N) ? _
SNMP Community Name
The SNMP Community Name is a required field for NMS to read or write to a device.
Enter a string of 1 to 13 characters.
SNMP Community Name (public): _
The default entry is public. The current value is displayed in parentheses.
Disable Telnet Setup
Note: If this option is disabled, note that disabling both Telnet Setup and Port
77FE prevents users from accessing the setup menu from the network.
This setting defaults to the N (No) option. The Y (Yes) option disables access to
Setup Mode by Telnet (port 9999). It only allows access locally via the web pages
and the serial port of the unit.
Disable Telnet Setup (N) ? _
Disable TFTP Firmware Upgrade
This setting defaults to the N (No) option. The Y (Yes) option disables TFTP for
network firmware upgrades.
Disable TFTP Firmware Update (N) : _
With this option, download firmware upgrades over the serial port using
DeviceInstaller’s Recover Firmware procedure (see Using TFTP: Command Line
Interface
To download new firmware from a computer, enter the following from a TFTP
command line interface:
tftp –i <ip address> put <local filename> <destination
file name>
The following examples demonstrate the TFTP command sequence to download the
.rom file, the .fwx file, and the .cob file:
tftp –i 192.168.1.111 put wpt540.rom W1
tftp –i 192.168.1.111 put H2_FW_200.fwx FWX1
tftp –i 192.168.1.111 put wpt_wm110.cob WEB1>
Recovering the Firmware Using the Serial Port on page 8-2).
Disable Port 77FE (Hex)
Note: Disabling both Telnet Setup and Port 77FE prevents users from
accessing the setup menu from the network.
Port 77FE is used by DeviceInstaller, Web-Manager, and custom programs to
configure the unit remotely. If required, disable this capability for security purposes.