Filter
Top Products
5: Configuration via Telnet or Serial Port (Setup Mode)
Note: The easiest way to enter Setup Mode is to hold down the x key at the terminal
(or emulation) while resetting the unit. You must do this within three seconds of
resetting the xPico.
At this point, the screen display is the same as when you use a Telnet connection. To
continue, go to step 4, above, in the section, Telnet Connection
.
Exiting Setup Mode
To exit setup mode:
You have two options:
To save all changes and reboot the device, select option 9 Save and exit from
the Change Setup menu. All values are stored in nonvolatile memory.
To exit the configuration mode without saving any changes or rebooting, select
option 8 Exit without save from the Change Setup menu.
xPico User Guide 36