Filter
Top Products
11: Monitor Mode
Table 11-1. Monitor Mode Commands
Command
Command Name
Function
VS x.x.x.x
Version
Queries software header record (16 bytes) of unit
with IP address x.x.x.x.
GC x.x.x.x
Get Configuration
Gets configuration of unit with IP address x.x.x.x as
hex records (120 bytes).
SC x.x.x.x
Send Configuration
Sets configuration of unit with IP address x.x.x.x
from hex records.
PI x.x.x.x
Ping
Pings unit with IP address x.x.x.x to check device
status.
AT
ARP Table
Shows the unit’s ARP table entries.
TT
TCP Connection
Table
Shows all incoming and outgoing TCP connections.
NC
Network Connection
Shows the unit’s IP address, gateway, subnet
mask, and DNS server.
RS
Reset
Resets the unit’s power.
QU
Quit
Exits diagnostics mode.
G0, G1, ....,Ge, Gf
Get configuration
from memory page
Gets a memory page of configuration information
from the device.
S0, S1,...,Se, Sf
Set configuration to
memory page
Sets a memory page of configuration information
on the device.
GM
Get MAC address
Shows the unit's 6-byte MAC address.
SS
Set Security record
Sets the Security record without the encryption key
and length parameters. The entire record must still
be written, but the encryption-specific bytes do not
need to be provided (they can be null since they
are not overwritten).
SA
Scan
Initiates a wireless scan if the wireless interface is
enabled. Reports any stations found, including
BSSID, SSID, and RSSI. If SA is followed by a
string, the string is used to filter SSIDs before
reporting. If the BSS does not broadcast its SSID,
only the BSSID and RSSI are returned.
NS
Network Status
Reports the network interfaces’ statuses. Includes
potentially negotiated parameters like speed/duplex
for Ethernet or BSSID, encryption, authentication
for wireless interfaces.
co
Set IP address,
hostbits, gateway ,
and DNS server IP
Example:
co 192.168.0.10 8 192.168.0.1 10001 192.168.1.10
with
192.168.0.10 = IP address of the xPico
8 = number of hostbits
192.168.0.1 = gateway IP address
10001 = port number of the xPico Channel 1
192.168.1.10 = IP address of the DNS Server
The xPico stores the setup and performs a reset. It
sends an X before the reset if the command was
OK.
Note: Entering any of the commands listed above generates one of the following
command response codes:
xPico User Guide 71