Lantronix 10 Network Card User Manual


 
Introduction
1-12
UDS-10 User Guide
1.13 Power Requirements
The UDS-10 is shipped with a 12VDC, 1A power supply, but any DC power supply between
9VDC and 30VDC can be used. You can order the UDS-10 with a 110VAC (UDS-10-01) or
230VAC (UDS-10-02) power supply.
Note: The input voltage for all UDS-10 products has been changed from 6-9VDC to 9-
30VDC. The new power supply shipped with the product supplies voltage within the new 9-
30VDC range. Please note that this new power supply should only be used with the 9-30VDC
UDS-10 products. The correct input voltage is marked on a label above the power socket
and on the back of the unit.
Power Socket
1.14 Reset Switch
The unit has a reset switch located next to the RJ-45 connector. This reset switch will reboot
the UDS when pressed.
Reset Switch