Filter
Top Products
Configure
3-14
UDS-10 User Guide
3.5.4 Change Telnet configuration password
Setting the Telnet configuration password prevents unauthorized access of the setup menu via
a Telnet connection to port 9999 or via Web pages. The password is limited to 4 characters.
An enhanced password setting of 16 characters is available under Security Settings for Telnet
access only.
Note: No password is required to access the Setup Mode window via a serial connection.
3.5.5 DHCP Naming
There are 3 methods for assigning DHCP names to these products.
1) Default DHCP name. If you do not change the DHCP name, and you are using an IP of
0.0.0.0, then the DHCP name will default to CXXXXXX (XXXXXX is the last 6 digits of the
MAC address shown on the label on the bottom/side of the unit). For example, if the MAC
address is 00-20-4A-12-34-56, then the default DHCP name is C123456.
2) Custom DHCP name. You can create your own DHCP name on these products. If you are
using an IP address of 0.0.0.0, then the last option in "Server configuration" will be "Change
DHCP device name". The "Change DHCP device name" option will allow you to change the
DHCP name to an alpha numeric name.
Change DHCP device name (not set) ? (N) Y
Enter new DHCP device name : LTX
3) Numeric DHCP name. You are able to change the DHCP name by specifying the last
octet of the IP address. When you use this method, the DHCP name will be LTXYY where
YY is what you chose for the last octet of the IP address. If the IP address you specify is
0.0.0.12, then the DHCP name will be LTX12. This method will only work with 2 digit
numbers (0-99).