Filter
Top Products
3: Getting Started
UDS1100 User Guide 14
Installing the UDS
Figure 3-1. UDS1100 Connected to Serial Device and Network
To install the unit:
Complete the following steps in order. Refer to the numbers in the figure above.
Note: See the sections that follow for details about connectors and pinouts.
1. Connect a serial device to your unit.
2. Connect an Ethernet cable to the RJ45 port.
3. Supply power to your unit using the power supply that was included in the
packaging.
Note: The required input voltage is 9-30 VDC (center +) or 10-24 VAC
(1.5W maximum power required).
4. Supply power to the serial device.
Note: If you encounter a problem, please see LEDs on page 65 for
diagnostic information.