Filter
Top Products
• “1110 Bluetooth daughter card” on page 84
• “1120 Backup battery” on page 85
• “1130 Smart Card or Smart Card dummy spacer” on page 86
• “1140 Speaker assembly” on page 88
• “1150 Thermal module” on page 89
• “1160 CPU” on page 92
• “1170 LCD unit” on page 93
• “1180 Base cover assembly” on page 96
• “1190 I/O sub card” on page 98
Important notices for RAID setting:
Before you replace the system board, make sure that you read Chapter 5 “Installing and conguring RAID” on
page 51
, and have the necessary information. After you replaced the system board, RAID mode is recovered
as default. To conrm the SATA mode setting, you can see the setting in ThinkPad Setup menu as follows:
Cong ➙ Serial ATA (SATA) ➙ SATA Controller Mode Option ➙ RAID/Compatibility/AHCI
Important notices for handling the system board:
When handling the system board, bear the following in mind.
• The system board has an accelerometer, which can be broken by applying several thousands of G-forces.
Note: Dropping a system board from a height of as little as 6 inches so that it falls at on a hard bench can subject
the accelerometer to as much as 6,000 G's of shock.
• Be careful not to drop the system board on a bench top that has a hard surface, such as metal, wood, or composite.
• If a system board is dropped, you must test it, using PC-Doctor for DOS if the system supports PC-Doctor for DOS,
to make sure that the HDD Active Protection still functions (see below).
Note: If the test shows that HDD Active Protection is not functioning, be sure to document the drop in any reject
report, and replace the system board.
• Avoid rough handling of any kind.
• At every point in the process, be sure not to drop or stack the system board.
• If you put a system board down, be sure to put it only on a padded surface such as an ESD mat or conductive
corrugated material.
If the system supports PC-Doctor for DOS, after replacing the system board, run PC-Doctor for DOS to make sure that
HDD Active Protection still functions. The procedure is as follows:
1. Place the computer on a horizontal surface.
2. Run Diagnostics ➙ ThinkPad Devices ➙ HDD Active Protection Test.
Attention: Do not apply physical shock to the computer while the test is running.
Location of major sensitive components on the system board
Following components soldered on the top side of the system board are extremely sensitive. When you
service the system board, avoid any kind of rough handling.
a
CPU
b
Accelerometer chip for the HDD Active Protection System™
c
PCH (Platform Controller Hub)
d
Graphics
Note:
d (Graphics) is only for the Switchable Graphics models and Workstation models. The
system board in Integrated Graphics models does not have this chip.
100 Hardware Maintenance Manual