Safety Information
Observe the following guidelines when using your px6-300d Network Storage:
● Follow all instructions marked on the px6-300d and in the documentation.
● Use only the power supply provided with the px6-300d.
● Unplug the px6-300d before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for
cleaning.
● Do not use the px6-300d near water. Do not spill liquid on or into the px6-300d.
● Do not place the px6-300d on an unstable surface.
● Do not place the px6-300d near or on a radiator or heat register.
● Openings in the px6-300d are provided for fans and air ventilation and should not be blocked or
covered. Make sure the px6-300d has ample ventilation (at least 6 inches or 127 mm) in front and
behind the unit.
● Do not walk on the power cord or allow anything to rest on it.
● There is a danger of explosion if the coin cell lithium battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the equipment manufacturer. Dispose of used
batteries according to local, state, regional, and federal regulations.
Under any of the following conditions, unplug the px6-300d from the wall outlet and contact technical
support:
● The power cord or plug is damaged.
● Liquid has been spilled into the device.
● The device does not function properly when the operating instructions are followed.
● The device was dropped or the exterior enclosure is damaged.
Legal
148 Safety Information