Filter
Top Products
Command Line Interface
4-58
4
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Command Usage
The unit ID is displayed using the port status LED indicators for ports 1 to 8.
When the light unit command is entered, the LED corresponding to the
switch’s ID will flash for about 15 seconds.
Example
show startup-config
This command displays the configuration file stored in non-volatile memory that is
used to start up the system.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• Use this command in conjunction with the show running-config command to
compare the information in running memory to the information stored in
non-volatile memory.
• This command displays settings for key command modes. Each mode group
is separated by “!” symbols, and includes the configuration mode command,
and corresponding commands. This command displays the following
information:
- SNMP community strings
- Users (names and access levels)
- VLAN database (VLAN ID, name and state)
- VLAN configuration settings for each interface
- IP address configured for the switch
- Spanning tree settings
- Any configured settings for the console port and Telnet
Console#light unit 1
Console#