Filter
Top Products
Command Line Interface
4-70
4
Example
This example shows the information displayed by the whichboot command. See
the table under the dir command for a description of the file information displayed by
this command.
boot system
This command specifies the image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of the configuration file or code image.
• unit* - Specifies the unit number.
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified unit number and file type.
• If the file contains an error, it cannot be set as the default file.
Example
Related Commands
dir (4-68)
whichboot (4-69)
Console#whichboot
file name file type startup size (byte)
------------------------------------- -------------- ------- -----------
Unit1:
D2218 Boot-Rom image Y 214000
V2264-J Operation Code Y 1754316
startup Config File Y 3251
Console#
Console(config)#boot system config: startup
Console(config)#