Filter
Top Products
Wireless Broadband router User Guide
Macintosh Clients
From your Macintosh, you can access the Internet via the Wireless Broadband router.
The procedure is as follows.
1. Open the TCP/IP Control Panel.
2. Select Ethernet from the Connect via pop-up menu.
3. Select Using DHCP Server from the Configure pop-up menu. The DHCP Client ID
field can be left blank.
4. Close the TCP/IP panel, saving your settings.
Note:
If using manually assigned IP addresses instead of DHCP, the required changes are:
• Set the Broadband router Address field to the Wireless Broadband router's IP
Address.
• Ensure your DNS settings are correct.
Linux Clients
To access the Internet via the Wireless Broadband router, it is only necessary to set
the Wireless Broadband router as the "Gateway".
Ensure you are logged in as "root" before attempting any changes.
Fixed IP Address
By default, most Unix installations use a fixed IP Address. If you wish to continue
using a fixed IP Address, make the following changes to your configuration.
• Set your "Default Gateway" to the IP Address of the Wireless Broadband router.
• Ensure your DNS (Name server) settings are correct.
To act as a DHCP Client (recommended)
The procedure below may vary according to your version of Linux and X -windows
shell.
1. Start your X Windows client.
2. Select Control Panel - Network
3. Select the "Interface" entry for your Network card. Normally, this will be called
"eth0".
4. Click the Edit button, set the "protocol" to "DHCP", and save this data.
5. To apply your changes
• Use the "Deactivate" and "Activate" buttons, if available.
• OR, restart your system.
Other Unix Systems
To access the Internet via the Wireless Broadband router:
• Ensure the "Gateway" field for your network card is set to the IP Address of the
Wireless Broadband router.
• Ensure your DNS (Name Server) settings are correct.
32