Filter
Top Products
Page 11
If the desired LevelOne Printer Server is not listed:
• Check all cables to the LevelOne Printer Server.
• Check the LevelOne Printer Server's LEDs:
• The Red LED should be OFF and the Green LED should be ON or flashing.
• If your model supports 10BaseT and 100BaseT, check the 10/100BaseT link LED
next to the LAN connection. If the auto negotiation fails, the 10/100BaseT Link LED
will not light when the device is powered up. (If there are 2 LEDs, neither will light.)
• Check that your PC has either the TCP/IP or NetBEUI network protocols installed.
See Checking your Network Protocols for details.
• If you PC can't configure the LevelOne Printer Server correctly (in Infrastructure mode),
then try to connect to LAN and disable the Wireless.
Wireless Configuration
For the WPS-0100 and WPS-0100USB, which include Wireless Stations, the Wizard will
display a "Wireless" configuration screen.
For further details about the WPS-0100 and WPS-0100USBs' Wireless Station feature, refer to
Wireless Configuration in Chapter 7 - Special Features.
The WPS-0100 and WPS-0100USB do NOT allow both a LAN
connection and "Infrastructure" mode.
To use "Infrastructure" mode, you must DISCONNECT the LAN
cable after configuration.
If using "Ad-hoc" mode, the LAN cable can be left connected,
and both the LAN and Wireless interfaces are available.
Alternatives to the Windows Wizard
If you do not have a Windows 32 platform available, use one of the following methods to
configure the LevelOne Printer Server.
Web Browser Only available on 100BaseT models. See Chapter 6 - Web Interface
Setup for details.
FTP Using this method, the configuration file is downloaded from the
LevelOne Printer Server, edited, then sent back. No software needs to be
installed.
See the UNIX manual for details. The Unix manual is on the CD-ROM,
in the Manual\Unix folder
WPConfig This program requires Windows 3.1, and the IPX/SPX protocol.
This program is on the CD-ROM, in the Utilities\WPConfig
folder. Instructions for using the program are in a sub-folder of the
Manual folder on the CD-ROM.
PSConfig Menu-based DOS program, intended only to configure the LevelOne
Printer Server for use with NetWare V2, 3 and 4.
This program is on the CD-ROM, in the Utilities\DOS folder.
Instructions for using the program are in a sub-folder of the Manual
folder on the CD-ROM.