Filter
Top Products
Page 6
LED Indicators
All models have two LED indicators on the top. The Status/Error LED is orange or red. The
Power/Link indicator LED is green. The LED indicator modes are described in the following
table.
Green LED Red/Orange LED Status Description
Off Off No power.
On On Hardware error.
Flashing Flashing Firmware upgrade in progress.
On Flashing (USB only) No printer connected to the USB port.
On Off Normal operation - idle.
Flashing Off Normal operation - transmitting or
receiving packets from the network.
LEDs - WPS-0100 and WPS-0100USB
The WPS-0100 and WPS-0100USB have 2 additional LED indicators as follows:
LED Description
WLAN ACT Off - Idle
Flashing - Transmitting or receiving data through the Wireless
LAN.
LAN ACT Off - Idle
Flashing - Transmitting or receiving data through the LAN.
Diagnostic Push Button
LevelOne Printer Server models WPS-0100 and WPS-0100USB are fitted with a Diagnostic
Push Button. The button is recessed; a pin or paper clip can be used to press it. This button has
2 functions:
• Restore the factory default settings
• Print a test page containing all current settings.
To restore the factory default settings:
1. Turn the LevelOne Printer Server OFF.
2. Press and hold the diagnostic button. While pressing the button, switch the LevelOne
Printer Server ON.
3. If you continue pressing the button for 10 seconds, a diagnostic page will be printed,
showing the new (default) settings.
To generate a Diagnostic print out
1. Ensure that both the LevelOne Printer Server and the printer attached to port 1 are ON.
2. Press the diagnostic button, and hold it in for 2 seconds.