Filter
Top Products
Load up to Make sure
25 sheets of labels
• The print side of the labels faces you.
• The top of the labels feeds into the printer first.
• The adhesive on the labels does not extend to within 1 mm of the
edge of the label.
• You use full label sheets. Partial sheets (with areas exposed by
missing labels) may cause labels to peel off during printing, resulting
in a paper jam.
• The labels are loaded against the right side of the paper support.
• The paper guide rests against the left edge of the labels.
Note: Labels require more drying time. Remove each sheet of labels as
it exits, and allow it to dry to avoid ink smudging.
50 transparencies
• The rough side of the transparencies faces you.
• If the transparencies have a removable strip, each strip faces away
from you and down toward the printer.
• The transparencies are loaded against the right side of the paper
support.
• The paper guide rests against the left edge of the transparencies.
Notes:
• Transparencies with paper backing sheets are not recommended.
• Transparencies require more drying time. Remove each
transparency as it exits, and allow it to dry to avoid ink smudging.
100 sheets of custom-size paper
• The print side of the paper faces you.
• The paper size fits within these dimensions:
Width:
– 76–216 mm
– 3.0–8.5 inches
Length:
– 127–432 mm
– 5.0–17.0 inches
• The paper is loaded against the right side of the paper support.
• The paper guide rests against the left edge of the paper.
29